HP105 plasma torch height controller is equipped with constant current plasma. During cutting courses, the current always equals the given current. And the cutting arc voltage will be changed with the fixed speed being the height of torch changing.
- When the distance gets farther,the arc voltage increases; On the opposite, the arc voltage will decrease. HP105 plasma arc voltage height controller will inspect the voltage change, then control the distance between cutting torch and material via the lift motor. So that the arc voltage is fixed, the same is the height of cutting torch. Generally, the instruction will list all the cutting parameters for some type of plasma.
- The user can refer to these parameters. Adjust the voltage in the arc voltage height controller to match the selected current. The torch height will keep constant under regular speed. In fact, the user should set the arc voltage according to the height of the cutting torch. In the status of automation, the arc voltage higher, then the height of the cutting torch higher.
Specification:
Working voltage: DC24±10%,50Hz/60Hz,Please prepare an isolated power, do not share with others such as an electronic valve. Especial Pay more attention the DC 24V
Lift motor: DC24V DC motor
Drive mode: PWM
Output current: 1A-4A.
Working temperature: Height controller -10∽60℃
HS style: Switch inspecting IHS (suitable for all plasma
both above-water and under-water cutting), Plasma Shield
Protector IHS (suitable for above-water cutting’s touch
leading arc voltage plasma)
Running transfer: Alternative Arc transfer and pierce transfer
Divided voltage ratio:100:1
Accuracy: ±1V∽±5V, adjustable
Dimension: 225mmX50mmX80mm
Weight: 0.8kg
Protection class: IP64, to prevent dust from entering.
Installation connector: 2-pin, 4-pin, 5-pin, DB-9 core
Installation position: Keep away from heat, air convection good place.
Function Description:
LCD: display the working status and parameters.
Manual: Auto / Manual mode selection increase, alternating work.
Arc test: standby press, arcing into the test mode.When arcing test, press to return to standby mode.
Menu: In standby, mode press to enter the parameter setting mode.
When the parameter setting Press to return to standby.
Confirmation: parameter setting mode, confirm that the set parameters.
Rise/fall: In standby mode, manual lifting torch.When parameter sets, subtraction parameter values.
JYKB-100-DC24V Plasma Flame THC Lifter Description:
1. This plasma cutting machine Z-axis torch lifter is driven by DC gear motor to lift the torch up & down
2. The most important part of the device, which is to keep the machine's cutting accuracy and to support plasma arc positioning function, is equipped with NPN proximity switches
3. This lifter's mechanical movement part is made of Taiwan TBI ball screw, standard linear shaft(SFC) & linear slider on the ends; holder is made of bearing steel, and fastened by linear sliders, which is to ensure the lifter movement's stability & verticality
4. Convenient to install, work simple, improving the work efficiency
Air control plug definition:
1 foot --D +; (motor positive)
2 feet --D -; (motor negative)
3 feet --Zero; (positioning normally open output)
4 feet --COM; (positioning normally open output)
Note: Built-in limit (reverse diode)
Parameter:
1. T-304 stainless steel screw
2. Includes jig (torch range 12mm-38mm)
3. Lift inside a plasma arc positioning
4. Aluminum body, the upper and lower aluminum sheet thickness of 8mm, forming a processing center
5. Four-core plug
6. Colour: black spray housing
7. Working stroke: 100mm
8. Working voltage: DC24V
9. Bearing weight: 3kg
10. Dimensions: 320x80x60mm
11. Mounting Hole Size Length: the center distance between two holes 40mm